- Home /
- Nox Composites
Shop By
Currently Shopping by
- Category: Remove This Item Boyd Cycling Bike Wheels
Filter
- Category
-
- Wheel Packages By Brand (56)
- Wheel Packages By Wheel Type (56)
- Rims (18)
- Bitex Bike Wheels (5)
- Chris King Bike Wheels (4)
- Hope Tech Bike Wheels (7)
- Industry Nine Bike Wheels (5)
- NOX Composite Bike Wheels (7)
- Onyx Racing Bike Wheels (7)
- Paul Components Bike Wheels (2)
- Phil Wood Bike Wheels (1)
- Shimano Custom Bike Wheels (5)
- Son Dynamo Bike Wheels (7)
- White Industries Bike Wheels (6)
Nox Composites
There are no products matching the selection.
I've done factory wheels and built my own wheels in the past, which has lead to a preference for a good quality, hand built set of wheels on each of my bikes. This time, I was looking to do something unique, and possibly custom, for my road bike.Michael Halliwell May 26, 2017
After a fair bit of searching, comparing and general navel gazing trying to figure out what I'd build, I found that ProWheelBuilder.com (PWB) would give me the best bang for the buck on the parts I had decided on. I ended up having PWB assemble the wheels too...it was a free service with the parts purchase and the incremental cost for duties (wheelsets vs. parts have different duty rates when bringing them into Canada) more than makes up for my time in assembling them myself.
My going more custom than just selecting the parts threw a bit of a wrench in the system, but the gang at PWB made sure things got sorted out in short order. My custom colored, custom engraved Onyx hubs with a leading / trailing pattern of colored spokes were well built into my selected rims. Obvious quality and attention to detail were evident from the packaging of the rims for shipment to the wheels themselves. Straight and true hand built wheels done using the parts I wanted and in the way I wanted them put together...who could ask for more?
Whether for parts or complete wheels, I recommend PWB.
I'm still new at wheel building But I learn very quickly and I needed more information on how to properly take Hub measurements to type into the Spoke calculater! So I went to UBI and read how to correctly take measurements and I typed it into their calculater and the difference between theirs and Prowheelbuilers is that Prowheelbuilders was more accurate than UBI's calculater. I did Not know if I should add or subtract to the closest mm: of measurement? So I compared the two different options and Prowheelbuilders Calculater made it easier for me to decide on what length I should go with! if I would have used the length that UBI calculated it would have been a little bit to Short on my Drive side! I figured what the Hell I'll go with prowheelbuilders calculation and it paided off for me! The Spoke Lengths Where Right on the Money!!!. I'm Well Pleased with my New DT Swiss Spokes and they look great as well! I'm using rims with offset spoke holes and I subtracted 1mm from the None drive side and added 1mm To the Drive side like I should and Prowheelbuiders was more accurate! I laced a Novatec D882SB Rear Hub up to a Loaded AmX Gold Anodized Free ride rim with ERD: of 532 and it is running very Smoothly!Joseph T Riker December 15, 2013