- Home /
- Nox Composites
Shop By
Currently Shopping by
- Axle Size: Remove This Item Bolt On Rear 10x120mm
- Bearing Adjustable: Remove This Item Adjustable
- Bearing Type: Remove This Item Angular Cartridge
- Color: Remove This Item Black
- Drillings: Remove This Item 48 hole
- Tire Type: Remove This Item Clincher
Filter
- Axle Size
- Bearing Type
Nox Composites
There are no products matching the selection.
After a long & fruitless search for a prebuilt wheel with the specs and price I wanted, I came across PWB. In just a few minutes on their well designed website I put together a wheel with exactly what I'd been looking for, and at a good price. The wheel came nicely packaged and perfectly tuned. I've put about 1000 miles on it and am 100% satisfied. I'll be back for more!Chris K September 13, 2018
I'm still new at wheel building But I learn very quickly and I needed more information on how to properly take Hub measurements to type into the Spoke calculater! So I went to UBI and read how to correctly take measurements and I typed it into their calculater and the difference between theirs and Prowheelbuilers is that Prowheelbuilders was more accurate than UBI's calculater. I did Not know if I should add or subtract to the closest mm: of measurement? So I compared the two different options and Prowheelbuilders Calculater made it easier for me to decide on what length I should go with! if I would have used the length that UBI calculated it would have been a little bit to Short on my Drive side! I figured what the Hell I'll go with prowheelbuilders calculation and it paided off for me! The Spoke Lengths Where Right on the Money!!!. I'm Well Pleased with my New DT Swiss Spokes and they look great as well! I'm using rims with offset spoke holes and I subtracted 1mm from the None drive side and added 1mm To the Drive side like I should and Prowheelbuiders was more accurate! I laced a Novatec D882SB Rear Hub up to a Loaded AmX Gold Anodized Free ride rim with ERD: of 532 and it is running very Smoothly!Joseph T Riker December 15, 2013