- Home /
- Nox Composites
Shop By
Currently Shopping by
- Axle Size: Remove This Item QR Front 9x135mm
- Bearing Adjustable: Remove This Item Adjustable
- Bearing Type: Remove This Item Angular Cartridge
- Rim Size: Remove This Item 700 / 29in
- Tire Type: Remove This Item Clincher
Filter
Nox Composites
There are no products matching the selection.
Ordered a set of FlowEx with black spokes and red nipples laced to red Chris King hubs.David from the Big Island, Hawaii January 14, 2013
I knew I was going to have to be patient as the Christmas rush and holidays coming up. Richard was nice to stay in contact with me on the status of my wheels. Needless to say when they wheels arrived, it was worth the wait! They came out BEAUTIFUL!! I checked the trueness and tension and they were topnotch.
I've been building up a dream bike using a Santa Cruz Blur LTc, SRAM components, KS Lev, Fox fork/shock, Easton Have carbon bars, Thompson stem, Candy pedals. The last piece to finish off the bike were the ProBuilder wheels. Putting on the wheels and seeing the complete bike was just a huge sigh of satisfaction and accomplishment for me, know I ordered the right wheelsets.
Thank Richard and ProWheelBuilder.com!!!
I'm still new at wheel building But I learn very quickly and I needed more information on how to properly take Hub measurements to type into the Spoke calculater! So I went to UBI and read how to correctly take measurements and I typed it into their calculater and the difference between theirs and Prowheelbuilers is that Prowheelbuilders was more accurate than UBI's calculater. I did Not know if I should add or subtract to the closest mm: of measurement? So I compared the two different options and Prowheelbuilders Calculater made it easier for me to decide on what length I should go with! if I would have used the length that UBI calculated it would have been a little bit to Short on my Drive side! I figured what the Hell I'll go with prowheelbuilders calculation and it paided off for me! The Spoke Lengths Where Right on the Money!!!. I'm Well Pleased with my New DT Swiss Spokes and they look great as well! I'm using rims with offset spoke holes and I subtracted 1mm from the None drive side and added 1mm To the Drive side like I should and Prowheelbuiders was more accurate! I laced a Novatec D882SB Rear Hub up to a Loaded AmX Gold Anodized Free ride rim with ERD: of 532 and it is running very Smoothly!Joseph T Riker December 15, 2013