- Home /
- Nox Composites
Shop By
Currently Shopping by
- Axle Size: Remove This Item QR Rear 10x120mm
- Bearing Adjustable: Remove This Item Adjustable
- Bearing Type: Remove This Item Angular Cartridge
Filter
- Axle Size
- Thru Axle Rear 12x135mm (6)
- Thru Axle Rear 12x142mm (7)
- Thru Axle Rear 12x170mm (2)
- Thru Axle Rear 12x177mm (2)
- Thru Axle Rear 12x190mm (2)
- Thru Axle Rear 12x197mm (2)
- QR Front 9x100mm (9)
- QR Rear 10x130mm (6)
- QR Rear 10x135mm (10)
- QR Rear 10x145mm (4)
- QR Rear 10x170mm (2)
- QR Rear 10x190mm (2)
- QR Front 9x135mm (2)
- QR Front 9x150mm (1)
- Thru Axle Front 9x100mm (2)
- Thru Axle Front 9x150mm (1)
- Thru Axle Rear 10x135mm (6)
- Thru Axle Front 12x100mm (6)
- Thru Axle Front 15x100mm (5)
- Thru Axle Front 15x110mm Boost (4)
- Thru Axle Front 12x150mm (1)
- Thru Axle Front 15x135mm (1)
- Thru Axle Front 20x110mm Boost (2)
- Thru Axle Front 15x150mm (2)
- Bolt On Rear 10x135mm (4)
- Lefty 60mm 2.0 Super Max (3)
- Lefty 73mm Olaf (3)
Nox Composites
There are no products matching the selection.
After my bike was stolen, I began to look around for inspiration and ideas on what my next ride would be. I am a bit of a deal hunter and I really have to give it to Richard when it comes to providing amazing service and value to his customers. I spent a lot of time looking into parts for building my new set of wheels and nothing came close to matching or beating the price and convenience offered by prowheelbuilders.com. Quality really does speak for itself and the H Plus Son Archetypes matched with Surly Ultra New hubs that Richard put together for me are an absolute dream. Thank you guys so much!!!jonathon kindle September 23, 2020
I'm still new at wheel building But I learn very quickly and I needed more information on how to properly take Hub measurements to type into the Spoke calculater! So I went to UBI and read how to correctly take measurements and I typed it into their calculater and the difference between theirs and Prowheelbuilers is that Prowheelbuilders was more accurate than UBI's calculater. I did Not know if I should add or subtract to the closest mm: of measurement? So I compared the two different options and Prowheelbuilders Calculater made it easier for me to decide on what length I should go with! if I would have used the length that UBI calculated it would have been a little bit to Short on my Drive side! I figured what the Hell I'll go with prowheelbuilders calculation and it paided off for me! The Spoke Lengths Where Right on the Money!!!. I'm Well Pleased with my New DT Swiss Spokes and they look great as well! I'm using rims with offset spoke holes and I subtracted 1mm from the None drive side and added 1mm To the Drive side like I should and Prowheelbuiders was more accurate! I laced a Novatec D882SB Rear Hub up to a Loaded AmX Gold Anodized Free ride rim with ERD: of 532 and it is running very Smoothly!Joseph T Riker December 15, 2013