- Home /
- Nox Composites
Shop By
Currently Shopping by
- Axle Size: Remove This Item QR Rear 10x126mm
- Bearing Adjustable: Remove This Item Adjustable
- Bearing Type: Cartridge Angular Cartridge
- Color: Remove This Item Yellow
- Material: Brass Aluminum Rims
- Tire Type: Remove This Item Tubular
Filter
- Axle Size
- Thru Axle Rear 12x135mm (2)
- Thru Axle Rear 12x142mm (3)
- QR Front 9x100mm (3)
- QR Rear 10x130mm (2)
- QR Rear 10x135mm (3)
- QR Rear 10x145mm (1)
- Thru Axle Front 9x100mm (1)
- Thru Axle Rear 10x135mm (2)
- Thru Axle Front 12x100mm (3)
- Thru Axle Front 15x100mm (2)
- Thru Axle Front 15x110mm Boost (1)
- Thru Axle Front 20x110mm Boost (1)
- Bolt On Rear 10x135mm (2)
- Lefty 60mm 2.0 Super Max (1)
- Lefty 73mm Olaf (1)
Nox Composites - Brass - Aluminum Rims
There are no products matching the selection.
I purchased spokes and nipples to rebuild 2 sets of wheels. I was able to get the exact sizes I needed. I think it's worth paying a small amount extra to get quality products in the correct size. I would highly recommend this vendor.Mike November 28, 2022
I'm still new at wheel building But I learn very quickly and I needed more information on how to properly take Hub measurements to type into the Spoke calculater! So I went to UBI and read how to correctly take measurements and I typed it into their calculater and the difference between theirs and Prowheelbuilers is that Prowheelbuilders was more accurate than UBI's calculater. I did Not know if I should add or subtract to the closest mm: of measurement? So I compared the two different options and Prowheelbuilders Calculater made it easier for me to decide on what length I should go with! if I would have used the length that UBI calculated it would have been a little bit to Short on my Drive side! I figured what the Hell I'll go with prowheelbuilders calculation and it paided off for me! The Spoke Lengths Where Right on the Money!!!. I'm Well Pleased with my New DT Swiss Spokes and they look great as well! I'm using rims with offset spoke holes and I subtracted 1mm from the None drive side and added 1mm To the Drive side like I should and Prowheelbuiders was more accurate! I laced a Novatec D882SB Rear Hub up to a Loaded AmX Gold Anodized Free ride rim with ERD: of 532 and it is running very Smoothly!Joseph T Riker December 15, 2013