I have been a mechanic for over 20 years now and even partially owned my own shop. I built quite a few wheels and definitely trued many more.I do all my maintenance myself and would have loved to build these wheels but I don't have the tools available any longer. I moved on to aircraft maintenance as it was a logical step for me. I know quality and craftsmanship when I see it. I could tell even before I took them out of the box. They were packed very well. I am glad I did my research and found ProWheelBuilder. The build quality was exceptional. Thank you! You are now my go to for wheels and my first recommendation.
May 12, 2016
I'm still new at wheel building But I learn very quickly and I needed more information on how to properly take Hub measurements to type into the Spoke calculater! So I went to UBI and read how to correctly take measurements and I typed it into their calculater and the difference between theirs and Prowheelbuilers is that Prowheelbuilders was more accurate than UBI's calculater. I did Not know if I should add or subtract to the closest mm: of measurement? So I compared the two different options and Prowheelbuilders Calculater made it easier for me to decide on what length I should go with! if I would have used the length that UBI calculated it would have been a little bit to Short on my Drive side! I figured what the Hell I'll go with prowheelbuilders calculation and it paided off for me! The Spoke Lengths Where Right on the Money!!!. I'm Well Pleased with my New DT Swiss Spokes and they look great as well! I'm using rims with offset spoke holes and I subtracted 1mm from the None drive side and added 1mm To the Drive side like I should and Prowheelbuiders was more accurate! I laced a Novatec D882SB Rear Hub up to a Loaded AmX Gold Anodized Free ride rim with ERD: of 532 and it is running very Smoothly!