- Home /
- Nox Composites
Shop By
Currently Shopping by
- Axle Size: Remove This Item Thru Axle Rear 12x148mm Boost
- Bearing Adjustable: Remove This Item Adjustable
- Bearing Type: Remove This Item Angular Cartridge
- Material: Brass Aluminum Rims Aluminum Hubs
- Tire Type: Remove This Item Tubular
Filter
- Axle Size
- Thru Axle Rear 12x135mm (2)
- Thru Axle Rear 12x142mm (3)
- QR Front 9x100mm (3)
- QR Rear 10x130mm (2)
- QR Rear 10x135mm (3)
- QR Rear 10x145mm (1)
- Thru Axle Front 9x100mm (1)
- Thru Axle Rear 10x135mm (2)
- Thru Axle Front 12x100mm (3)
- Thru Axle Front 15x100mm (2)
- Thru Axle Front 15x110mm Boost (1)
- Thru Axle Front 20x110mm Boost (1)
- Bolt On Rear 10x135mm (2)
- Lefty 60mm 2.0 Super Max (1)
- Lefty 73mm Olaf (1)
Nox Composites - Brass - Aluminum Rims - Aluminum Hubs
There are no products matching the selection.
I'm still new at wheel building But I learn very quickly and I needed more information on how to properly take Hub measurements to type into the Spoke calculater! So I went to UBI and read how to correctly take measurements and I typed it into their calculater and the difference between theirs and Prowheelbuilers is that Prowheelbuilders was more accurate than UBI's calculater. I did Not know if I should add or subtract to the closest mm: of measurement? So I compared the two different options and Prowheelbuilders Calculater made it easier for me to decide on what length I should go with! if I would have used the length that UBI calculated it would have been a little bit to Short on my Drive side! I figured what the Hell I'll go with prowheelbuilders calculation and it paided off for me! The Spoke Lengths Where Right on the Money!!!. I'm Well Pleased with my New DT Swiss Spokes and they look great as well! I'm using rims with offset spoke holes and I subtracted 1mm from the None drive side and added 1mm To the Drive side like I should and Prowheelbuiders was more accurate! I laced a Novatec D882SB Rear Hub up to a Loaded AmX Gold Anodized Free ride rim with ERD: of 532 and it is running very Smoothly!Joseph T Riker December 15, 2013
I had a custom wheelset made. I received them 3 weeks from the order date. They were dead true and all the spokes had equal tensions. I took them out on a 55 mile maiden cruse and they are flawless. I got a lot of comments from friends about how sharp these wheels look on my Orbea. Black hubs and nipples with white spokes and white Deep V's. It really makes the bike unique. Thanks Richard for the lacing advise and top notch wheel smithing. These wheels are bomb proof.Tony Buck May 22, 2009