Once I placed my order, I received a phone call, the very next morning. About a small error, which was easily solved. This kind of follow through, shows the highest form of professionalism. I was told, that my purchase was already being collected. I then patiently waited, like a child for Christmas Morning, for my Wheel to arrive. Upon arrival, I opened the oddly shaped box, to Unveil, what I shall say is one of the finest pieces of Craftsmanship I have seen in Years. So, Special Thanks to Preston, who laced my wheel, and to Richard who masterfully Trued and Shipped my Wheel. AWESOME Job Fellas !!! here is a Pic. of it mounted on my Bike.
October 08, 2014
I'm still new at wheel building But I learn very quickly and I needed more information on how to properly take Hub measurements to type into the Spoke calculater! So I went to UBI and read how to correctly take measurements and I typed it into their calculater and the difference between theirs and Prowheelbuilers is that Prowheelbuilders was more accurate than UBI's calculater. I did Not know if I should add or subtract to the closest mm: of measurement? So I compared the two different options and Prowheelbuilders Calculater made it easier for me to decide on what length I should go with! if I would have used the length that UBI calculated it would have been a little bit to Short on my Drive side! I figured what the Hell I'll go with prowheelbuilders calculation and it paided off for me! The Spoke Lengths Where Right on the Money!!!. I'm Well Pleased with my New DT Swiss Spokes and they look great as well! I'm using rims with offset spoke holes and I subtracted 1mm from the None drive side and added 1mm To the Drive side like I should and Prowheelbuiders was more accurate! I laced a Novatec D882SB Rear Hub up to a Loaded AmX Gold Anodized Free ride rim with ERD: of 532 and it is running very Smoothly!