- Home /
- WTB
Shop By
Currently Shopping by
- Axle Size: Remove This Item Thru Axle Rear 12x142mm
- Color: Polished Gold Green
- Price: Remove This Item $139.00 - $9.99
- Rim Size: Remove This Item 26in
WTB
There are no products matching the selection.
I can't say enough good things about PWB. My road bike gets daily abuse on a long, hilly commute over bad roads and gravel trails. I was looking for something that was light enough to climb well, tough enough for gravel, and precise enough to handle long descents through mountain switchbacks. The ride has chewed up two stock Bontrager wheelsets and even a set of Mavics. Local wheelbuilders weren't able to quote me anything they thought would work for less than a grand.Dan Chapman November 12, 2016
I considered a wide range of rims, hubs, and wheelbuilders before Debra at PWB suggested I take a look at the Ventus Premium wheelset. Watching a YouTube video of them bombing down trails gave me confidence that they might fit the bill. I'm glad I took her advice. They are light, responsive, and hold true even after a few months on gravel, and the custom red hubs look really sharp to boot.
I'm still new at wheel building But I learn very quickly and I needed more information on how to properly take Hub measurements to type into the Spoke calculater! So I went to UBI and read how to correctly take measurements and I typed it into their calculater and the difference between theirs and Prowheelbuilers is that Prowheelbuilders was more accurate than UBI's calculater. I did Not know if I should add or subtract to the closest mm: of measurement? So I compared the two different options and Prowheelbuilders Calculater made it easier for me to decide on what length I should go with! if I would have used the length that UBI calculated it would have been a little bit to Short on my Drive side! I figured what the Hell I'll go with prowheelbuilders calculation and it paided off for me! The Spoke Lengths Where Right on the Money!!!. I'm Well Pleased with my New DT Swiss Spokes and they look great as well! I'm using rims with offset spoke holes and I subtracted 1mm from the None drive side and added 1mm To the Drive side like I should and Prowheelbuiders was more accurate! I laced a Novatec D882SB Rear Hub up to a Loaded AmX Gold Anodized Free ride rim with ERD: of 532 and it is running very Smoothly!Joseph T Riker December 15, 2013