Search results for 'race face arc 40 29 in black rim'
-
Park Tool offers a variety of high quality spoke wrenches that are built to last.
· Unique four-sided design provides extra strength and support and helps prevent slipping and deformation of aluminum nipples
-
Park Tool offers a variety of high quality spoke wrenches that are built to last.
· Fits DT and Wheelsmith
· Professional quality, precision-sized spoke wrenches are hardened and nickel plated for long service
· Vinyl coated in one of four colors indicating the size at a glance
-
For a wheel to perform properly, it is important for the rim to be centered between the locknuts of the hub, or “dished.” The WAG-5 accurately gauges dish on 24 x 1-38" to 29" wheels (ETRTO or ISO sizing of 571 to 630). Disassembles quickly for storage or travel and works with all hub types.
-
For a wheel to perform properly, it is important for the rim to be centered between the locknuts of the hub, or “dished.” To check this, and to make precision adjustments, a wheel alignment gauge (also called a “dishing tool”) is a must. An accurate and truly versatile wheel alignment gauge that belongs along side every truing stand.
-
The TS-TA makes it possible to adapt all Park Tool Truing Stands to work with 12mm, 15mm, 20mm, and 25mm thru axle front wheels, as well as Cannondale® Lefty™ wheels.
The TS-TA also work with the rear 135mm thru axle hubs in the TS-2.2 and TS-3. The TS-TA when used in the TS-8, TS-25, TS-15, TS-7 or TS-5 will work with all rear thru axle hubs.
-
Allows truing stand to be used with 12mm, 15mm, 20mm, and 25mm thru axle hubs. Axles must be removed to use adaptors. Adaptors mount easily to TS-2.2 or TS-2.
-
Park TS-2 EXT.2 Truing Stand Upright Extensions install in seconds on any TS-2 Truing Stand, allowing the stand to be used on wheels with hubs up to 200mm wide (tandem, fat and downhill bikes),
· Allows the Park TS-2.2 truing stand to accommodate hubs up to 200mm
· Allows the Park TS-2 truing stand to accommodate hubs up to 170mm
· Allows the Park TS-2 truing stand to accommodate 29" wheels with tires installed when combined with #238K caliper upgrade kit QBP part # TL8603
· Specially sized bosses allow the TS-2.2 and TS-2 truing stands to work with 12, 15,20 and 25mm thru axle hubs with removable axles
-
Designed to fit internal spoke nipples found on many deep section aero rims.
· Built with a comfortable, dual density grip and lined with precision bronze bearings to ensure a long, smooth running life
· Works with rims up to 50mm deep
· The SW-15 combines 3.2mm square drive and 5mm and 5.5mm hex sockets to fit internal spoke nipples
· Works on wheels made by numerous manufacturers, including, but not limited to: FSA, Blackwell, Planet-X, HED, Rolf, Bontrager, Campagnolo and Mavic
-
The SW-16.3 offers an extra long reach (3.25" / 8.25cm) for those deep section aero rims. Featuring our dual-density ergonomically-designed screwdriver handle.