- Home /
- WTB
Shop By
Currently Shopping by
- Axle Size: Remove This Item Bolt On Rear 10x126mm
- Bearing Type: Remove This Item Cartridge
- Color: Polished Gold Blue Green Pewter
- Rim Size: Remove This Item 650b / 27.5in
Filter
- Axle Size
- Thru Axle Rear 12x135mm (8)
- Thru Axle Rear 12x142mm (8)
- Thru Axle Rear 12x170mm (3)
- Thru Axle Rear 12x177mm (3)
- Thru Axle Rear 12x190mm (3)
- Thru Axle Rear 12x197mm (3)
- QR Front 9x100mm (7)
- QR Rear 10x135mm (8)
- QR Rear 10x170mm (3)
- QR Rear 10x190mm (3)
- QR Front 9x135mm (2)
- QR Front 9x150mm (2)
- Thru Axle Front 9x100mm (2)
- Thru Axle Front 9x150mm (2)
- Thru Axle Rear 10x135mm (8)
- Thru Axle Front 12x100mm (7)
- Thru Axle Front 15x100mm (7)
- Thru Axle Front 15x110mm Boost (3)
- Thru Axle Front 12x150mm (2)
- Thru Axle Front 15x135mm (2)
- Thru Axle Front 20x110mm Boost (2)
- Thru Axle Front 15x150mm (3)
- Bolt On Rear 10x135mm (4)
- Lefty 60mm 2.0 Super Max (3)
- Lefty 73mm Olaf (3)
- Bearing Type
WTB
There are no products matching the selection.
ProWheelBuilder is great to work with before, during and after the order. Easy to communicate with and customer service is top notch. I would absolutely recommend PWB for your next wheelsetSteven Pedretti October 09, 2022
I'm still new at wheel building But I learn very quickly and I needed more information on how to properly take Hub measurements to type into the Spoke calculater! So I went to UBI and read how to correctly take measurements and I typed it into their calculater and the difference between theirs and Prowheelbuilers is that Prowheelbuilders was more accurate than UBI's calculater. I did Not know if I should add or subtract to the closest mm: of measurement? So I compared the two different options and Prowheelbuilders Calculater made it easier for me to decide on what length I should go with! if I would have used the length that UBI calculated it would have been a little bit to Short on my Drive side! I figured what the Hell I'll go with prowheelbuilders calculation and it paided off for me! The Spoke Lengths Where Right on the Money!!!. I'm Well Pleased with my New DT Swiss Spokes and they look great as well! I'm using rims with offset spoke holes and I subtracted 1mm from the None drive side and added 1mm To the Drive side like I should and Prowheelbuiders was more accurate! I laced a Novatec D882SB Rear Hub up to a Loaded AmX Gold Anodized Free ride rim with ERD: of 532 and it is running very Smoothly!Joseph T Riker December 15, 2013